-Easy Installation. Self-adhesive tape included.
-4 Flash Modes: Brake;Running;Turn Signal;Hazard Light(Double Flash)
-LED light stays in Red when brake.
-LED Light keeps in Ice Blue during normal running.
-LED Light flows from left to right when car turns left and from right to left when car turns right.
-LED Light flows from middle to ends when use Hazard Light (Double Flash).
-LED Color: Ice Blue & Red
-Size: Approx. L*W*D:120cm*1cm*0.5cm 47”*0.4”*0.2”
Red Wire-ACC or 12V DC Power Positive
Black Wire-Ground or 12V DC Power Negative
Yellow L-Turn Signal Left Positive
Yellow R-Turn Signal Right Positive
Green Wire-ACC or Rear LED Light Positive (Stays in Ice Blue when normal Driving)
White Wire-Brake Light Positive
Simple Installation Step:
1. Select desired mounting position and make sure that the surface is clean and clear of dirt, water or wax.
2. Peel off the 3M tape and stick the tailgate bar following the edge onto the car.
3.Connect the power cord to vehicle and connect the long black wire to 12V power
-Please follow Wiring Instruction and wire the light.
-Please DO NOT cut or damage the light.
-Please DO NOT bend or fold the light to 90°
-Please DO NOT overly stretch or pull the light during installation.
- 4 Flash Modes: Brake;Running;Turn Signal;Hazard Light(Double Flash).
- Made with high quality led chips, double color, ice blue and red with flashing function.
- Easy To Install: No aluminum No drill. Silicone body, fully sealed, do not worry about rust. Just peel and stick it by using reliable Self-Adhesive Genuine tape.
- LED light stays in Red when brake,keeps in Ice Blue during normal running.
- Flows from right to left when car turns left and from left to right when car turns right. Flows from middle to ends when use Hazard Light (Double Flash).